|
|
Post by elm on Jun 13, 2016 1:08:39 GMT
So I kind of threw myself in the deep end here. They grey shetland moorland pony didn't look as bad in the photos on ebay but is a bit worse in person. In fact the seller said the AQH was the worst but I think its the best of the 3 condition wise. Can anyone guess the chestnuts mould? Seller didn't know. What is the best way to repair these? s723.photobucket.com/user/elizabeth_duncan3/library/Julip%20Repairs |
|
|
|
Post by FarfraeFarm on Jun 13, 2016 5:58:15 GMT
|
|
|
|
Post by elm on Jun 13, 2016 10:25:19 GMT
Thanks, so cut off the sticky legs/hooves and remake with milliput basically? Kinda scary but I think I'll start with the AQH, atleast its only her legs and ears. Do I also use milliput to fill in the tiny cracks?
|
|
|
|
Post by astudyinscarlet on Jun 13, 2016 11:56:02 GMT
The grey isn't a shetland, that's a moorland pony. I think the chestnut is probably a hack.
|
|
|
|
Post by elm on Jun 13, 2016 22:15:58 GMT
The grey isn't a shetland, that's a moorland pony. I think the chestnut is probably a hack. Thanks, yea on looking at pictures of shetland ponies I didn't think it quite looked like one. |
|
|
|
Post by elm on Jun 14, 2016 21:13:33 GMT
What do I do about soft/sticky mouths?
|
|
|
|
Post by FarfraeFarm on Jun 16, 2016 12:01:31 GMT
What do I do about soft/sticky mouths? I'm really not sure. My models were so bad they had to be completely encased in milliput |
|
|
|
Post by Manda on Jun 16, 2016 18:15:05 GMT
Good Grief! Someone still looks at my old website? Wow!
For sticky mouths I usually remove the lower jaw and re build with milliput
|
|
|
|
Post by FarfraeFarm on Jun 16, 2016 20:20:14 GMT
Good Grief! Someone still looks at my old website? Wow! For sticky mouths I usually remove the lower jaw and re build with milliput yep. And it wasan excellent resource, too  thank you for your tutorials |
|
|
|
Post by elm on Jun 16, 2016 22:02:02 GMT
Good Grief! Someone still looks at my old website? Wow! For sticky mouths I usually remove the lower jaw and re build with milliput Thank you. There is one I think might be out of my depth for repairing so I might message you about it after I have attempted the other two. |
|
thank you for your tutorials